Become a Site Supporter and Never see Ads again!

Author Topic: 1/8" Stereo to Bal XLR????  (Read 1051 times)

0 Members and 1 Guest are viewing this topic.

Offline anodyne33

  • You'll have that
  • Trade Count: (0)
  • Needs to get out more...
  • *****
  • Posts: 14307
  • Gender: Male
  • All my life there's been the magnets.
    • Lucky
1/8" Stereo to Bal XLR????
« on: November 15, 2005, 11:21:40 AM »
Hoping there's an interconnect genius that can set me right on this one. I need to go from an 1/8" headphone output (on a laptop) to an XLR input for a courtroom soundsystem. I'd like to preserve both channels of audio to the mono XLR input. My initial thinking is;
Pin2 = T & R
Pin3 = S
Pin1 - float

Will I have any summing issues by connecting T & R (left & right) together? Will it be a problem to float Pin1?

I'm probably going to eng up hacking into a cable and figuring it out for myself, but I'd like to have a good starting point. This HAS to be WAY more simple than I'm making it... either that or damn near impossible!

Thanks
Pockets full of nickels and nothing left to eat, and I'm stuck behind a semi on Soniat Street.

Offline heath

  • Laugh it up, Fuzzball...
  • Trade Count: (4)
  • Needs to get out more...
  • *****
  • Posts: 24792
  • Gender: Male
  • I'm score!!!!!!
    • The Upstream Mend
Re: 1/8" Stereo to Bal XLR????
« Reply #1 on: November 15, 2005, 12:52:43 PM »
tie low to ground. 
« Last Edit: November 15, 2005, 12:55:34 PM by heath »
And the Sultans... yeah the Sultans play creole

 The Upstream Mend

 

RSS | Mobile
Page created in 0.093 seconds with 29 queries.
© 2002-2018 Taperssection.com
Powered by SMF