Become a Site Supporter and Never see Ads again!

Author Topic: "brightening" up a tape  (Read 1181 times)

0 Members and 1 Guest are viewing this topic.

Offline admkrk

  • Trade Count: (0)
  • Taperssection All-Star
  • ****
  • Posts: 1637
  • I'm an idiot
"brightening" up a tape
« on: November 17, 2005, 04:18:31 PM »
w/ the naks and the warm mod my tapes tend to come out a bit on the heavy side. normly i don't mind. on this one though, the band might use it on a cd and i'd like to clean it up a bit before sending it tomorrow. i've never tryed to do anything like this before and was wondering if there was some thing i could do in wavelab(or sf) to bring out the top end a little more?  thanks in advance,
 
                       kirk
"the faster you go ahead, the behinder you get"

"If you can drink ram's piss, fuck, you can drink anything"

Offline nic

  • Big In Japan
  • Trade Count: (1)
  • Needs to get out more...
  • *****
  • Posts: 4704
  • Gender: Male
    • half dead batteries
Re: "brightening" up a tape
« Reply #1 on: November 17, 2005, 04:27:19 PM »
open up the spectral analysis tool so you get some idea of the frequency response.
it may be easier to eq down the low end and then raise the overall volume of the set


the water's clean and innocent

Offline admkrk

  • Trade Count: (0)
  • Taperssection All-Star
  • ****
  • Posts: 1637
  • I'm an idiot
Re: "brightening" up a tape
« Reply #2 on: November 17, 2005, 05:11:02 PM »
open up the spectral analysis tool so you get some idea of the frequency response.
it may be easier to eq down the low end and then raise the overall volume of the set

i'll check that out when i get back home. 
"the faster you go ahead, the behinder you get"

"If you can drink ram's piss, fuck, you can drink anything"

 

RSS | Mobile
Page created in 0.066 seconds with 44 queries.
© 2002-2019 Taperssection.com
Powered by SMF