I use it for my D8 (use prosumer out on V3, the other will give you a copy prohibit warning)
Ok here's what you need:
1-rt-angle female XLR
1-junk 7-pin head (mine used to be an optical, someone sent me when I asked on Oade board a while back, any will work)
1-meter Canare 110ohm cable
1-female RCA end on cable (I had a couple on a cable I had here)
shrink wrap, solder, & small soldering iron
Patience, take your time & do it right...
first connect the RCA to the stripped ends of the Canare cable Shield to ground (white) Center to red, solder & shrinkwrap, leaving enough wire exposed to connect to the pins on the 7-pin
open 7 pin, hack out whatever you have to to see the pin heads, you will also have to widen the cable opening a bit on the 7-pin with an exacto knife to make it close(you want the insulation on the canare cable to end just outside the 7-pin).
l o o o o /
l o o o /
1. connect pins 3 & 6 (enable digital in)
2. connect the ground (I used the white shielded wire) to either the piece you used to bridge these pins, or pin 6
3. connect orange shielded wire to pin 5
4. put the top back on 7pin
tip: tin the ends of the wire first, then bend 90 degrees with needle nose
For the XLR end:
1. connect pin 2 to the orange
2. connect pin 3 to the white (ground)
leave pin 1 shield unused
Test it out, then when you know it works open the 7 pin and fill with silicone.