Taperssection.com
Gear / Technical Help => Ask The Tapers => Topic started by: Big Perm on September 03, 2009, 01:29:15 PM
-
when i connected my new mme to my pmd671 and hit record I get an error message E3... 671 is set to digi in, not sure what the issue is
-
E3 ="Read after write is not available during recording with MP2, or 24 bit and 96/88.2 kHZ PCM" according to manual....not sure what that means
-
Its all good, Doug to the resque. well in case anyone is wondering, the monitor switch has to be on source not file when recording at a highr bit rate. I must have switched it to file by accident when reworking my bag to create room for the MME