Become a Site Supporter and Never see Ads again!
« previous next »
Pages: [1]   Go Down

Author Topic: M1 error  (Read 1830 times)

0 Members and 1 Guest are viewing this topic.

Offline T.J.

  • Trade Count: (2)
  • Needs to get out more...
  • *****
  • Posts: 2474
  • Gender: Male
  • Always look on the Bright Side of Life
    • My shows taped on LMA
M1 error
« on: February 28, 2005, 02:23:08 PM »
i've got a quick question i can't find an answer to: Sometimes while using my M1 recording at 44.1, i'll hit record and the M1 will blink
"F-44 1" before it writes id. it only happens randomly, and when it flashes my recording always comes out fine. what does this mean?
Logged

Offline dnsacks

  • Trade Count: (9)
  • Taperssection All-Star
  • ****
  • Posts: 1640
Re: M1 error
« Reply #1 on: February 28, 2005, 02:26:08 PM »
If you hold down the play button, the m1 (or d100 or d7 or d8) will show the sample rate the tape's being played/recorded at. Sounds like you're holding down the play button for a long enough time for the m1 to tell you the sample rate that's being recorded.
Logged

Offline T.J.

  • Trade Count: (2)
  • Needs to get out more...
  • *****
  • Posts: 2474
  • Gender: Male
  • Always look on the Bright Side of Life
    • My shows taped on LMA
Re: M1 error
« Reply #2 on: February 28, 2005, 02:34:48 PM »
maybe...i will hit record and pause together, and then hit play to actually begin recording. i just want to make sure there is nothing wrong with the recorder, b/c i'll probably be putting it up for sale soon. i've had a very short lived DAT taping career...jb3 is the way to go  ;D
Logged
Pages: [1]   Go Up
« previous next »
 

RSS | Mobile
Page created in 0.025 seconds with 31 queries.
© 2002-2024 Taperssection.com
Powered by SMF