Become a Site Supporter and Never see Ads again!
« previous next »
Pages: 1 [2]  All   Go Down

Author Topic: Running neumann ak20?  (Read 6467 times)

0 Members and 1 Guest are viewing this topic.

Offline F.O.Bean

  • Team Schoeps Tapir that
  • Trade Count: (126)
  • Needs to get out more...
  • *****
  • Posts: 40690
  • Gender: Male
  • Taperus Maximus
    • MediaFire Recordings
Re: Running neumann ak20?
« Reply #15 on: April 24, 2015, 02:13:31 PM »
Nice Dan! Im sure Brian can figure something out
Logged
Schoeps MK 4V & MK 41V ->
Schoeps 250|0 KCY's (x2) ->
Naiant +60v|Low Noise PFA's (x2) ->
DarkTrain Right Angle Stubby XLR's (x3) ->
Sound Devices MixPre-6 & MixPre-3

http://www.archive.org/bookmarks/diskobean
http://www.archive.org/bookmarks/Bean420
http://bt.etree.org/mytorrents.php
http://www.mediafire.com/folder/j9eu80jpuaubz/Recordings

Offline morst

  • I think I found an error on the internet; #UnionStrong
  • Trade Count: (2)
  • Needs to get out more...
  • *****
  • Posts: 5979
Re: Running neumann ak20?
« Reply #16 on: May 03, 2015, 04:01:41 PM »
just a little bump to indicate my fascination with the topic!

Been thinking about 3-d printing mics mounts lately...

Also, I'd totally like to buy an AK20...
Logged
https://toad.social/@morst spoutible.com/morst post.news/@acffhmorst

Offline John Willett

  • Trade Count: (0)
  • Taperssection All-Star
  • ****
  • Posts: 1550
  • Gender: Male
  • Bio:
    • Sound-Link ProAudio
Re: Running neumann ak20?
« Reply #17 on: May 04, 2015, 09:35:19 AM »
Quote from: morst on May 03, 2015, 04:01:41 PM
Been thinking about 3-d printing mics mounts lately...

See HERE for a selection of 3D printed stereo clips - they are all designed to line up with the back of the mic. to make setting up fast and accurate - so you will always have the correct capsule spacing as well as the correct angle.
Logged
Pages: 1 [2]  All   Go Up
« previous next »
 

RSS | Mobile
Page created in 0.042 seconds with 29 queries.
© 2002-2024 Taperssection.com
Powered by SMF