Become a Site Supporter and Never see Ads again!

Author Topic: Neumann KK 14 Miniature Clip Mic System  (Read 20648 times)

0 Members and 1 Guest are viewing this topic.

Offline daspyknows

  • Complaint Dept.
  • Trade Count: (1)
  • Needs to get out more...
  • *****
  • Posts: 9585
  • Gender: Male
  • Don't ask, don't tell, don't get get caught
Re: Neumann KK 14 Miniature Clip Mic System
« Reply #90 on: July 24, 2023, 04:35:19 PM »
Nick (SchoepsNBox) making actives for these too.

I thought that was for the bigger version of the capsule, not the kk14.

Nick will confirm but I thought he said he had built some for the new Neumanns

Offline grawk

  • Trade Count: (3)
  • Taperssection Member
  • ***
  • Posts: 265
  • Gender: Male
Re: Neumann KK 14 Miniature Clip Mic System
« Reply #91 on: July 28, 2023, 02:03:28 PM »
I checked with Nick, it’s for the kk18x only
4015gs/4018vlgs/kk14->mma:a d-vice/sd 552/zoom f6/spdr

Offline Paul

  • Trade Count: (0)
  • Taperssection Newbie
  • *
  • Posts: 23
  • Gender: Male
Re: Neumann KK 14 Miniature Clip Mic System
« Reply #92 on: September 30, 2023, 04:33:03 AM »
I picked up a pair of the MCM 114 (guitar) mic's & tried them out tonight at the JBLZE. I was disappointed w/ the sound, at the venue, as I was 12th row, center & the FOH was going right over our heads. The sound was boomy & lacking midrange.

When everybody stood up in front of us & we stood too, there was a better mix, by about 60%. You could now hear guitar & the vocals sounded full throated. But, I was doing a stealth recording, so, when everyone sat back down, I had to sit too...

Anyway, I did some EQ, balance & a little compression, & here's a track. Recorded w/ the Zoom F3 192kHz/32bit. I used the mic's in a typical x-y, w/ the polar patterns criss-crossing each other similar to this, maybe a little closer together, & less of a spread (angle)...



sample:
https://www.dropbox.com/scl/fi/uetbvxai0npbmgvik1ago/Kashmir-JBLZE.flac?rlkey=c1ontufaanm4p6g7v9w42q9sq&dl=0
« Last Edit: September 30, 2023, 04:39:02 AM by Paul »
my 2¢...

 

RSS | Mobile
Page created in 0.039 seconds with 27 queries.
© 2002-2024 Taperssection.com
Powered by SMF