Topic: Lunatec V2 jumper help/questions......

[F.O.Bean]

ive read the v2 manual and all that jazz, and just want to make sure my HPF is set to low and all that jazz, and was wondering if anyone had any tips on changing the v2 jumpers. the v3 jumpers were like tabs you just push to one side or the other, these are QUITE different, i dont know how to even change them

[F.O.Bean]

OK, think I have it figured out, once the black plastic jumper is over where it needs to be its ACTIVE right?

[Teen Wolf Blitzer]

Jumpers?  What does that mean?  Is there something I should do to my V2?

[F.O.Bean]

Jumpers?  What does that mean?  Is there something I should do to my V2?

there are M/S and HPF jumpers in the v2/3, if theyre factory default, nothing to worry about

you can change the slope of the HPF from 6db/octave to 12db/octave and you can also change what frequency the 1 and 2 HPF slots cut off at

I wanted to switch mine back to the default 6db/octave_LOW cutoff(2-50HZ)(1-100HZ)

[Kyle]

OK, think I have it figured out, once the black plastic jumper is over where it needs to be its ACTIVE right?

Yours are black? Hmmm, I have white ones. I changed the HPF slope from 12dB/octave to 6dB/octave - just pull the plastic guy off and connect the pins are per the manual...


you got it...

[terrapinj]

HPF is for pussies bean   

[F.O.Bean]

HPF is for pussies bean   

I know Mikey, I just wanted my v2 to have factory default settings I dont plan on using it unless onstage for Lotus