Taperssection.com

Gear / Technical Help => Ask The Tapers => Topic started by: Massive Dynamic on December 15, 2004, 01:17:53 PM

Title: SBD > SBM question
Post by: Massive Dynamic on December 15, 2004, 01:17:53 PM

I searched the posts and noticed a few of you have taken sbd feeds into a SBM.  Do you typically need attenuators, or can the SBM-1 handle a very hot board feed?

Title: Re: SBD > SBM question
Post by: Teen Age Riot on December 16, 2004, 12:51:52 AM

I've done that dozens of times. Never needed an attenuator. If the levels seem too hot, just be nice and polite to the engineer, ask him/her to give you a little less output, and you're all good.

Title: Re: SBD > SBM question
Post by: edgar on December 16, 2004, 04:29:20 AM

Quote from: moon-pix on December 16, 2004, 12:51:52 AM

I've done that dozens of times. Never needed an attenuator. If the levels seem too hot, just be nice and polite to the engineer, ask him/her to give you a little less output, and you're all good.

yep. in fact its always good to have them start moderately...aabout 1/2 way up, and adjust accordingly yourself.

Title: Re: SBD > SBM question
Post by: Massive Dynamic on December 16, 2004, 07:07:11 PM

Thanks for the responses, +T.