Taperssection.com
Gear / Technical Help => Microphones & Setup => Topic started by: bkirby on September 12, 2003, 11:44:55 AM
-
Hey all,
Will AKG 480s or any of the Gefells fit in these shockmounts? If so, how snug? Who has the best price?
Brad K.
-
those should work fine
-
either one will be nice and snug. Try masterpiece for the best price. They were $60 each a while back but I guess there was some sort of price increase because I can't find them for under $68 now. "IMO", the 480's are a little too long for the a20s'. The AT 8410's work great with the 480's. If your trying to be more stealth, the a20s' would probably suite you better.
My $0.02,
Kevin
-
I have almost had it with the AT8410s as they keep requiring adjusting of that tiny damn screw. I have sent three pairs back to AT and they keep sending me brand new ones, but always end up with the same problem. I have tried everything from loc-tite, cement glue, super glue, and soldering. Nothing will hold it tight. I keep telling AT that this is the cause of bad engineering, and they agree, but nothing has been done!
-
I hear ya. The pair I owned were only used a couple times so I never experienced such problems. I know exactly what your talking about, though. The schoeps mounts will work, but I would suggest getting the a20s's (stiffer ones) instead of the a20's.
Kevin
-
+T
Thanks Kevin and Creek...
-
i also own 480's, and rather than getting the 8410's and getting my bodies scratched, i think i would rather purchase the 8415's.....they are similar to the sambras, but are MUCH better built and WAY more flexible than the sambras or the 8410's...... 8)my 00.02
bean
-
sambra's suck ass
-
The 8410s don't scratch the bodies if you use them properly. ;)