Become a Site Supporter and Never see Ads again!

Author Topic: Building a Microphone Cable (XLR) Question....  (Read 2901 times)

0 Members and 1 Guest are viewing this topic.

Offline cavernut

  • Trade Count: (0)
  • Taperssection Regular
  • **
  • Posts: 74
  • Gender: Male
Building a Microphone Cable (XLR) Question....
« on: April 26, 2009, 05:08:27 PM »
I am in the process of building a couple of XLR cables with 90 degree female ends.
From everything I've seen most cable comes in a single pair or in one Canari cable a Quad.
If I'm using the canari Quad aren't i still using one pair or Pos, One for Neg and one for GND?
OK an XLR having a Positive, A Negative and a Ground three wires are needed.
Is it normal procedure to use the Shield as the Ground?
Does anyone have any Cable recommendations.
Please help.

Thanks,

Michael
« Last Edit: April 26, 2009, 06:23:22 PM by cavernut »

Offline DSatz

  • Site Supporter
  • Trade Count: (35)
  • Needs to get out more...
  • *
  • Posts: 3347
  • Gender: Male
Re: Building a Microphone Cable (XLR) Question....
« Reply #1 on: September 05, 2009, 01:16:24 AM »
mshilarious wrote:

> Typically, pin 1 is tied directly to the preamp case at the input connector.

That would be the best practice by far for RF immunity, but many portable preamps and recorders (especially, but not exclusively, made in the Far East) seem not to follow it. I've seen an awful lot of gear that has its input and output connectors soldered directly to the main printed circuit board; those connectors then fit through holes in the case. If the equipment has a metal case and there's any connection between it and the circuit board's ground, often that connection is made through mounting parts such as screws or posts that touch ground traces on the PCB.

Basically, it's an invitation for induced shield currents (buzzy hum) to come right on in and get amplified, so it's way more important than what your cables are or aren't made of (that last statement won't help me win any popularity contests in this section of the forum, I realize).

--best regards
music > microphones > a recorder of some sort

 

RSS | Mobile
Page created in 0.052 seconds with 30 queries.
© 2002-2024 Taperssection.com
Powered by SMF