Taperssection.com

Gear / Technical Help => Playback Forum => Topic started by: phreshie on February 19, 2008, 04:14:31 PM

Title: ISO VIFA M21 WN series driver
Post by: phreshie on February 19, 2008, 04:14:31 PM

Any help appreciated. After seeing the 6mil dollar room in Ct with all the MacIntosh's and Snell loudspeakers I decided to pull my Snell E IV's out of the closet. Remembering why I put them in there years ago - I see the rip in the foam around the driver on only one of them. I've seen the posts about repairing this foam BUT would anyone have a clue where I might look to get a replacement driver ?
I need a VIFA M21 WN 07.
Years ago I had an audio supply house catalog and remember they had tons on VIFA's avail but not the one I needed.
Also if anyone can tell me if there is a substitute VIFA that I could use in place, likely to replace both drivers in each speaker if thats the case.

Thanks again.

Title: Re: ISO VIFA M21 WN series driver
Post by: BC on February 19, 2008, 06:56:47 PM

might want to check here?

http://www.partsexpress.com/