Taperssection.com

Gear / Technical Help => Recording Gear => Topic started by: blu666z on July 28, 2003, 08:04:54 PM

Title: Switching Inputs Mid Show
Post by: blu666z on July 28, 2003, 08:04:54 PM

Gonna be hitting a show tonite just so I can do a little comparisons w/ and wo/ the UA-5.  I have a D7 with a 7pin from the UA-5.  If they don't do 2 sets and I have to switch midset, do I have to stop the deck and restart it to switch from 7-pin to 1/8" Line-In.

-Kevin

Title: Re:Switching Inputs Mid Show
Post by: greenone on July 28, 2003, 11:23:16 PM

I think so - you may even have to cycle the power but I'm not 100% positive on that. If you yank the 7-pin it'll just read "No Input" until you stick the plug back in. I think that's the case if you switch from digi to analog or the other way around...

Title: Re:Switching Inputs Mid Show
Post by: Phil on August 03, 2003, 11:39:21 PM

So what are the results of your comparison?

Title: Re:Switching Inputs Mid Show
Post by: blu666z on August 05, 2003, 03:42:18 PM

Didn't get to do it.  I was going to be running a new right angle digital cable and it was faulty and didn't have a replacement with me.  Next time.

-Kevin

Title: Re:Switching Inputs Mid Show
Post by: JAH on August 06, 2003, 01:49:02 PM

Quote from: blu666z on July 28, 2003, 08:04:54 PM

Gonna be hitting a show tonite just so I can do a little comparisons w/ and wo/ the UA-5.  I have a D7 with a 7pin from the UA-5.  If they don't do 2 sets and I have to switch midset, do I have to stop the deck and restart it to switch from 7-pin to 1/8" Line-In.

-Kevin

Too bad it didn't happen but try it at home and see...then let us know too. ;D

peace
jah