Taperssection.com
Gear / Technical Help => Ask The Tapers => Topic started by: herrmann2burn on July 29, 2003, 11:41:33 PM
-
I have an AKG Bar that i havent been able to use because the center hole that would screw onto the stand is almost totally stripped.
Anyone know if i can get it re-threaded anywhere?
~Rhys
-
sounds like a job for this:
(http://images.orgill.com/200x200/4904744.jpg)
-
Call a few local machining shops, I would think that perhaps even auto shops that do work on exhausts or local plumbers might have tapping dies.
It's a 3/4" rough or 3/4-20 I believe...
-
Thanks for the advice.
I think im gonna pass on Lee's Idea, Ducting it everytime, seems more of a pain in the ass. Ill look around for a machine shop or something...or else ill just buy a new one ;)
-
i'd just get a new one. Only 20 bucks. & you can use the old one for parts if needed down the road.
-
sounds like a job for this:
(http://images.orgill.com/200x200/4904744.jpg)
like i always say...if ya can't duct it, FUCK IT!
-
if you can't fix it with duck tape, fuck it. it's broke