Become a Site Supporter and Never see Ads again!

Author Topic: whould this work?  (Read 2079 times)

0 Members and 1 Guest are viewing this topic.

Offline setboy

  • Trade Count: (5)
  • Needs to get out more...
  • *****
  • Posts: 5117
  • Gender: Male
whould this work?
« on: July 20, 2004, 02:37:48 PM »
 Audix 1290> Shure FP24>MIC 2496>JB3

any one know if this could work?

Offline Craig T

  • Trade Count: (10)
  • Needs to get out more...
  • *****
  • Posts: 4312
    • LMA
Re: whould this work?
« Reply #1 on: July 20, 2004, 02:50:19 PM »
why the Shure mic pre?  the mic2496 is a mic pre + a/d converter.
Schoeps cmc6/4v / Beyer mc950 / Line Audio CM3, OM1 / ADK A51 / Church Audio CA-14
Naiant Tinybox v2.2 / NBox(P) / Church Audio ST9200 / CA-UGLY
Sony PCM-M10 / Zoom F3 / Zoom F6

Offline Sean Gallemore

  • Trade Count: (2)
  • Needs to get out more...
  • *****
  • Posts: 8316
Re: whould this work?
« Reply #2 on: July 20, 2004, 04:59:04 PM »
i bet the JB3 a/d sounds better than that CS thing.

Offline setboy

  • Trade Count: (5)
  • Needs to get out more...
  • *****
  • Posts: 5117
  • Gender: Male
Re: whould this work?
« Reply #3 on: July 20, 2004, 11:17:14 PM »
why the Shure mic pre?  the mic2496 is a mic pre + a/d converter.

you know what i dont know why i have that in the mix

Raphael

Offline John Kelly

  • Been a while...
  • Trade Count: (1)
  • Needs to get out more...
  • *****
  • Posts: 9753
  • Gender: Male
    • The Jokell
Re: whould this work?
« Reply #4 on: July 21, 2004, 01:03:24 AM »
why the Shure mic pre?  the mic2496 is a mic pre + a/d converter.

you know what i dont know why i have that in the mix

Raphael

You were looking at my gear?  I dunno anyone else who runs the Shure... ;D
Sennheiser MKH8040st > SD 702
XBL/PSN/Steam ID: thejokell

 

RSS | Mobile
Page created in 0.062 seconds with 30 queries.
© 2002-2024 Taperssection.com
Powered by SMF