Topic: A couple of matrixing questions.

[wrangler_n_space]

Ok so i am thinking of trying this wensday night at Jerry Joeseph in T-town.
I do not want to do it post show. I just think that will be to big of a headache for me right now, so

Is there anyway i could it with my current setup?
skm140s>lc3>warmUA5>jb3
sbd>xlr>warmUA5>jb3
Will that work?

I also have a laptop, but i have a problem with it everytime i have tried to run it in the field. Any ideas?

[nickgregory]

you may have delay issues depending on how far away the mics are from the sound source

[wrangler_n_space]

Its in a very small bar. I could probably run onstage if need be.
I was planning on setting up dfc about 10ft back from the pa's.

[DaryanLenz]

You should be just fine!

Daryan

[wrangler_n_space]

You should be just fine!

With wich option.

Just running xlrs out of the soundboard into the ua5.

Will it send both signals to the JB3?

[DaryanLenz]

Well, there are only one set of xlr's on the ua-5, so you would need to go sbd->rca->ua5 or sbd->xlr->rca->ua5 unless you think you can run mics->rca...hehe!  You then would set the levels on the mics where you want them, and seperately set the levels on the sbd to where you want/wish they could be.  Then, start phantom power on the mics and assuming signal from the sbd is fine, you should be good to go!

Daryan

[wrangler_n_space]

Thanks, had a little brain fart this morning. Was thinking rca and typed xlr twice.

[DaryanLenz]

no problem my friend!

Daryan