0 Members and 2 Guests are viewing this topic.
I would honestly rather get rid of the external mics on this thing. I would never use them. Unless there was a way to take some AT853 (4.7k mod) and put them in that housing.You said you could make a new backing for it to make it slimmer. How would you go about this. I am curious. You have peaked my interest a lot!I did pull the trigger and order one of these. Looking forward to using it in a couple weeks time for my next show!
sitting beside the unit. pop off the rectangular rubber plug at the top
Quote from: jerryfreak on May 18, 2019, 08:53:11 PMsitting beside the unit. pop off the rectangular rubber plug at the topAny recommendations on how to do that without damaging it? Mine seems to be super glued.
While you’re doing all this surgery care to take a multimeter reading of the PIP voltage?
Quote from: ycoop on May 20, 2019, 01:41:24 PMWhile you’re doing all this surgery care to take a multimeter reading of the PIP voltage?you dont need to open it up to measure PIP, see older posts in this thread
2.75V unloaded, 2.2-2.4ish V loaded with DPAs