0 Members and 1 Guest are viewing this topic.
My Matthews telescopic baby stand extension arrived today (woohoo)!I’m now trying to figure out how to attach a stereo bar with 5/8” threads to the stud. It looks like I’ll need a rapid adapter, but I can only find them going from 5/8” stud to 3/8” or 1/4” threads. Do I have to go 5/8” stud > 3/8” or 1/4” threads > threaded adapter to 5/8” threads or are there 5/8” stud > 5/8” threads rapid adapters that I just can’t find?
I don't see any Stud adapters offhand with 5/8". Use something to convert the stereo bar https://www.amazon.com/CAMVATE-8-Inch-4-Inch-Adapter-Microphone/dp/B019TWBQIE/
Quote from: rippleish20 on June 13, 2018, 12:44:53 PMI don't see any Stud adapters offhand with 5/8". Use something to convert the stereo bar https://www.amazon.com/CAMVATE-8-Inch-4-Inch-Adapter-Microphone/dp/B019TWBQIE/Several of these in my bag.
Figured this was how I’d have to go. Just wanted to check before pulling the trigger.
Quote from: ycoop on June 13, 2018, 01:50:54 PMFigured this was how I’d have to go. Just wanted to check before pulling the trigger.These are the ones I use. https://www.bhphotovideo.com/c/product/1083039-REG/auray_ad_combo_s_5_8_to_3_8.htmlYou may want to buy two. You'll undoubtedly need a 2nd one or spare down the road for something.
CAMVATE Female 1/4"-20 to 5/8"-27 Male 2 Piece Mic Adapter https://www.amazon.com/dp/B01GWVQ022/ref=cm_sw_r_cp_api_i_OSviBbX8E2F96Already purchased this a few weeks ago so I’m covered.
Maybe consider a rapid adapter of some kind too. Makes setup and break down a snap. (or twist)https://www.bhphotovideo.com/c/search?Ntt=rapid%20adapter&N=0&InitialSearch=yes&sts=ma&Top+Nav-Search=
Quote from: rigpimp on June 13, 2018, 02:14:19 PMMaybe consider a rapid adapter of some kind too. Makes setup and break down a snap. (or twist)https://www.bhphotovideo.com/c/search?Ntt=rapid%20adapter&N=0&InitialSearch=yes&sts=ma&Top+Nav-Search=Got that about 20 minutes ago. Looks like I’m a step ahead of you today
Yup, kindms and I are thinking of one of these for our Mathews extension pole:https://www.bhphotovideo.com/c/product/824403-REG/Impact_ca_102_Rapid_Baby_to_3_8.htmlsame page as rigpimp listed, only this is the specific 3/8 inch stud.
Used the super clamp+telescopic extension for the first time last night. The clamp could only latch on in a way that caused the pole to be at an angle. Is there any way to avoid this with a superclamp or would a c clamp be the way to get it up perpendicular to the ledge?