Become a Site Supporter and Never see Ads again!
« previous next »
Pages: [1]   Go Down

Author Topic: Need advice on high-pass filtering  (Read 1681 times)

0 Members and 1 Guest are viewing this topic.

Offline pmforbin

  • Trade Count: (0)
  • Taperssection Newbie
  • *
  • Posts: 15
  • Gender: Male
  • Quick, get that robot a drink!
Need advice on high-pass filtering
« on: December 16, 2005, 07:46:02 PM »
Until my SD 722 arrived this week, my only experience with high-pass (low-cut) filters has been a simple on/off switch.  Now I've got lots of frequency and slope options for roll-off and I'm trying to learn as much as I can about which settings are likely to yield good results in various settings.  Can anyone offer advice?
Logged
Neumann KM-140 > AudioMagic Presto II > MDZ-10 > SD 722
I almost took up smoking, but then I decided I wanted to die fighting Ninjas.

zowie

  • Guest
  • Trade Count: (0)
Re: Need advice on high-pass filtering
« Reply #1 on: December 17, 2005, 07:37:45 PM »
Mine would be to leave it off and do your eq-ing in post, absent really extraordinary circumstances.  You can't put back what never gets on the tape.
Logged
Pages: [1]   Go Up
« previous next »
 

RSS | Mobile
Page created in 0.049 seconds with 26 queries.
© 2002-2024 Taperssection.com
Powered by SMF