Topic: 2 DPA 4061 MICRODOTs to 1 minijack stereo 3.5 ?? possible??

[chrisv31]

I have a set of 2 dpa 4061
i would like to replace the 2 original microdots with 1 minijack 3.5 stereo
if one of you have the solution, that will be very kind

is it possible to have a drawn or the shematic??

Chris

[Nick's Picks]

snip off the ends.

the raw wire has a shield and then a single *very, very thin* conductor inside.  the conductor is the HOT signal.
there is also a lot of fiber built into the wire that you need to remove.
You'll need a good wire stripper.
tiny bathroom type scissors for snipping the fabric away.

do this for each wire.  you now can solder on to your stereo plug.
twist up the two shields together and that becomes the ground.

or...PM me.  I'll do it for you if you dont want to deal w/it. 

[Arni99]

i did it here:
http://taperssection.com/index.php/topic,92042.0.html

but DON´T solder the yellow shielding like i did on the pic HAHA!
the yellow shielding needs to be removed and only the tiny main-conductor has to be soldered..1 to left the other one to thr right solderpoint on the stereo plug.

[chrisv31]

thanks for your help