Gear / Technical Help > Microphones & Setup
Shapeways mount... Connect to stand
Since85:
Hi all,
Wondering what folks out here with a shapeways capsule mount use for a secure and adjustable connection to a stand?
Any suggestions helpful, thank you :)
BlueSky71:
From the bottom of the SRS recording page, easy to miss down there. I use A53M's
IMPORTANT NOTE: Unless otherwise indicated, the mounts you see in this shop are designed to be used with a 20mm shock mount such as the Shure A53M, or a conventional 20mm microphone clip. Newer mounts are being designed to accommodate the Rycote INV-6 and INV-7 Lyre suspensions.
mrfender:
Or an A55M will work with a little gaffer tape around the bar. Not that I measured wrong or anything.
voltronic:
Scott seems to be mainly designing around Rycote Lyre mounts these days as Bluesky mentions.
It's important to get the right compliance for the combined mass you are isolating (mics+bar). If you need help selecting the right Lyres for the job, I can help.
Since85:
Thanks to all for the information that I was looking for.
Appreciate it :)
Navigation
[0] Message Index
[#] Next page
Go to full version