Gear / Technical Help > Microphones & Setup
Right Angle Pluggy XLR EM272Z1 mic vs. AT822
gihl:
I like my Audio-Technica AT822 stereo mic, but I'm considering the Right Angle Pluggy XLR EM272Z1 mic for simple/quick setup and handheld recording.
- https://micbooster.com/clippy-and-pluggy-microphones/298-right-angle-xlr-pluggy-em272.html
I mainly record city sounds with AT822 and Zoom F3.
I wonder if the Right Angle Pluggy XLR EM272Z1 mic is as good as the AT822.
I would really appreciate your advice. :)
mjwin:
Those EM272 based mics will give very little stereo separation if used as shown in the photo. FEL should know better than to suggest their use in this way, though I see that they do say as much in the small print below! Omni mics such as these need either a solid baffle between them, or spacing of at least 40cm or so.
If you want to try the EM272 mics, I would suggest that you either buy bare capsules and wire them yourself, or find some pre-wired into a 3,5mm jack. These you can use with your Roland R05 plug-in-power mic input, and save all the hassle and expense of phantom-power and XLRs etc.
The golden rule: Where you place the mics is more important than the mics themselves! Tiny capsules can be placed anywhere and, for cityscapes it's often advantageous to not draw attention to the fact that you're recording.
I have several sets of EM172/272 which I use with my Olympus LS10 with excellent results. One pair is built into the casing of some cheap headphones to give a discreet binaural recording rig. Another option is to clip a mic to each side of a backpack. Wrap each mic in a piece of fake fur or open weave fabric to roughly match your pack and provide some wind protection.
Incidentally, your AT822 is a good, directional stereo mic based on dual cardioid capsules. You can hold it in one hand, point it at something and it will do the job, providing some rejection of off axis sound. Omni mics are omnidirectional so they will record sound from all directions. This might be an advantage or disadvantage depending on the situation. Baffles or wide spacing affect things, too. Experimentation is fun! Only you with your skill as a sound recordist can decide what's best.
Happy sound hunting!
illconditioned:
AT822 is very good sounding and very flexible.
For a stereo image, point at source,For interviewing, put it between two speakers, either above or below head level.
If aimed correctly this microphone will not let you down.
moondust.and.solitude:
--- Quote from: illconditioned on November 15, 2022, 06:58:14 PM ---AT822 is very good sounding and very flexible.
For a stereo image, point at source,For interviewing, put it between two speakers, either above or below head level.
If aimed correctly this microphone will not let you down.
--- End quote ---
+1 on the AT822. I used one for a few years, no issues at all.
illconditioned:
--- Quote from: moondust.and.solitude on November 16, 2022, 04:03:13 PM ---
--- Quote from: illconditioned on November 15, 2022, 06:58:14 PM ---AT822 is very good sounding and very flexible.
For a stereo image, point at source,For interviewing, put it between two speakers, either above or below head level.
If aimed correctly this microphone will not let you down.
--- End quote ---
+1 on the AT822. I used one for a few years, no issues at all.
--- End quote ---
This is really the "secret weapon" for a lot of great recordings.For acoustic, rock or anything in between, get this as close to the front as possible.I've seen some clubs where this is permanently installed (AT825 phantom power version, but the same innards) and mixed with board feed. I recall one club giving all the artists a free live recording, mixed right to CD. Those were the days ...
Navigation
[0] Message Index
[#] Next page
Go to full version