Gear / Technical Help > Cables
how much to strip from starquad?
1st set only:
how much should i strip off from the ends of the star quad to make my mic cables?
leegeddy:
--- Quote from: The Donald on May 11, 2004, 01:28:27 PM ---how much should i strip off from the ends of the star quad to make my mic cables?
--- End quote ---
3/4" is plenty.
marc
1st set only:
I think ill try an inch my fingers can be fumbly
BCostigan:
I usually do an inch and trim them down before soldering to about 3/4".
I hate taking apart the ground :P
John R:
be careful not to take too much off, you want to give the strain relief something to bite onto.
jr
Navigation
[0] Message Index
[#] Next page
Go to full version