Gear / Technical Help > Cables
Looking for Digital In Cable for Tascam DR-100 MK2
GLouie:
I went to check on our DR100-MkII and MkIII cables (and charge the batteries). For the record, my never-used MkII cable is a 2.5mm TRRS to RCA, with shield to sleeve and signal to the lower ring. NC to tip or upper ring. The owner's manual states the digital input jack is TRS. I have not tried to figure out if the jack is really TRS and they just supplied a cable plug that works, but happens to be TRRS. A TS plug might not work.
My never-used MkIII digital input cable is 3.5mm TS to RCA, wired normally, although the manual says the input jack is TRS.
pic:
steve4134:
Correct the mk2 is 2.5mm and the mk3 is 3.5 mm.
Thank you
Steve
dallman:
It's in the mail. I am glad I could help!
dactylus:
--- Quote from: dallman on July 28, 2021, 01:43:12 AM ---It's in the mail. I am glad I could help!
--- End quote ---
+T dallman
:clapping:
steve4134:
Got the cable today. Thanks again everybody.
Steve
Navigation
[0] Message Index
[*] Previous page
Go to full version