bored....
AVS 2000 is designed to stabilize power line fluctuations and maintain constant voltage to your home theatre. Voltage sags (below the standard RMS value of 120 volts) are often caused by power-hungry appliances like clothes washers, air conditioners, and electric heaters, which draw more power (over 1500 watts) than your house was designed to support. This can have a direct effect on home theatre components, including amplifiers and two piece projection systems, which require a lot of power to operate at an optimum performance level. As a result, the picture can lose brightness and suddenly shrink in size. Amplifiers change gain structure which results in nasty distortions. They also won't deliver peak power, dropping from 100 watts to as low as 60 watts, for example. Your home theatre is very power hungry, too, often drawing twice as much power as a washer and air conditioner combined. This can cause even more voltage sags and ultimately, inferior home theatre performance. And, with the AVS 2000's sequential turn-on feature, your high power loads can operate at peak performance without causing unnecessary electrical stress that can often pop a circuit breaker or damage your components.
Panamax Max 5500....A Power monitoring system that acts as a gate to prevent unsafe voltages from damaging sensitive electronic equipment. It automatically detects a prolonged over or undervoltage condition and disconnects the power to equipment, then reconnects it when the power returns to a safe level. Two delayed turn-on outlets provide clean, filtered power without limiting the current available to the connected equipment.
*product fluffing not intentional...sorry*
Thanks....Jason
more info:
http://www.monstercable.com/http://www.panamax.com/