I'm having some issues with this and I feel like it's a dumb question or something obvious... I have Nak CM-100s > XLR > 1/4". The stock adapters are going XLR > 1/4" (male) > Radio shack Y adapter > 1/8" miniplug adapter > recorder. For some reason, Im getting a mono signal of both mics. They both respond in one channel on the recorder but the other channel is dead.
While on topic, does anyone use a similar setup into the line in on their recorder? I'd like to run a matrix of my Naks and Teacs(with omni caps) but when I ran them before the levels seemed pretty low going into the mic in (Tascam DR units). Just curious if line in would work. Maybe increase the voltage of the batteries I'm using? Don't want to fry the mics though...
I guess I could also do a matrix with a single omni in the center as well. Anyone have good results with that before?