Taperssection.com
Gear / Technical Help => Recording Gear => Topic started by: kkaye on October 07, 2006, 04:34:15 PM
-
So Ive got a D8 that I plan to use with a simple Sony Stereo mic, to tape a friends band in a bar.
I have some newbie questions:
Do I use the line or mic in for the mic input for my D8, and what would be the difference of the two?
Also its a typical bar so would I use the low or high sens setting if I use mic in?
Thanks, I'm a nervous newbie that doesnt know what to do
-
I'm kind of a rookie too, but from what I've read you can't go wrong with low sens and line in. If I'm wrong, I'm sure a more experienced taper will straighten me out. :D
-
thanks, show time in 3 hours, hopefully someone can comment,
I tried a couple other times and got distortion or is it brick wall? at the 12 db dot, where I try to peak levels at?
-
Check them on the first song and set accordingly I would say. Or, since this sounds open, you can easily monitor them throughout and adjust if need be. Always better to be a bit low and boost them later with software than be high and get clipping.