Taperssection.com
Gear / Technical Help => Remote Power => Topic started by: sparkey on December 17, 2008, 06:38:34 PM
-
So I just got my mitts on a V-2...no cables, batteries, nothin'. I did place a call to Kind Kables and there was no answer.
Any suggestions are greatly appreciated!
Josh
-
It's not too hard to make your own power cable if you're comfortable with soldering.
From the V2 manual:
"A four pin XLR connector is used for the DC power. [snip]... To avoid compatibility problems it is recommended that 6 Volt systems be wired to use pin 3 for hot (+6v) and pin2 for ground [snip]... The V2 current draw ranges from .38A to .62A depending on the microphone used."