Taperssection.com
Gear / Technical Help => Recording Gear => Topic started by: blu666z on April 22, 2003, 01:33:08 PM
-
I ordered my UA5 this morning. What cable will I need to go from the UA5 to an M1(if that is what I get)?
-Kevin
-
You'll need:
A digital coax cable (75ohm cable with RCA connectors) to get the signal out of your UA5.
A coax / 7-pin cable to get the signal into your M1/D100/7/8.
There are some notes in the Archival section under the Cables and Related thread. Check it out.
BTW, for an M1, I believe an active 7-pin cable is your best bet.
(Soon to come in the Archival section: a compilation of notes on the difference between active/passive 7-pins.)
-
Ok. Thanks. +T
-Kevin
-
I'm sure it goes without saying, but I hope you bought it from the Oades with a coax mod (or a used w/coax mod) otherwise you'll need a computer to get it to work with your M1.
-
I did. ;D
-Kevin
-
For use until I get my DAT, does the UA-5 have an optical output that I can use into my MD?
-Kevin
-
For use until I get my DAT, does the UA-5 have an optical output that I can use into my MD?
Yes.
-
Kevin,
It has optical, so you should be all set. I found a 8 D Cell battery pack I made for my ua-5, an extra ac adapter...do you want them??
Daryan