Become a Site Supporter and Never see Ads again!

Author Topic: Problem passing digital signal into Tascam DR100mk3  (Read 678 times)

0 Members and 1 Guest are viewing this topic.

Offline Melanie

  • (3)
  • Taperssection Member
  • ***
  • Posts: 635
Problem passing digital signal into Tascam DR100mk3
« on: December 21, 2020, 08:34:47 PM »
I am transferring DAT tapes from Tascam DA P1 to Tascam DR100mk3 and after setting source input to digital and hooking up proper connections I hit record, it goes into pause with no signal and I get a message saying Din signal mismatch. I've done this before with existing cable and not had this issue. I've also tried two other DAT machines with coax digital outs with no success. Any ideas?  Bob and Melanie

Offline mepaca

  • (10)
  • Taperssection Regular
  • **
  • Posts: 228
  • taperssection member
Re: Problem passing digital signal into Tascam DR100mk3
« Reply #1 on: December 21, 2020, 10:14:18 PM »
Please make sure that the bit rate and most importantly the sample rate are the same on both the dat recording and the DR100 mk3. If the sample rates are mismatched it will never transfer



Offline Melanie

  • (3)
  • Taperssection Member
  • ***
  • Posts: 635
Re: Problem passing digital signal into Tascam DR100mk3
« Reply #2 on: December 21, 2020, 11:11:28 PM »
Please make sure that the bit rate and most importantly the sample rate are the same on both the dat recording and the DR100 mk3. If the sample rates are mismatched it will never transfer
I'll try that, thanks. Bob

Offline Melanie

  • (3)
  • Taperssection Member
  • ***
  • Posts: 635
Re: Problem passing digital signal into Tascam DR100mk3
« Reply #3 on: December 22, 2020, 10:09:49 AM »
Please make sure that the bit rate and most importantly the sample rate are the same on both the dat recording and the DR100 mk3. If the sample rates are mismatched it will never transfer
I'll try that, thanks. Bob
Just reset DR100mk3 for 44.1 and signal passed just fine, thanks for quick response and help. Bob

 

RSS | Mobile
Page created in 0.044 seconds with 28 queries.
© 2002-2021 Taperssection.com
Powered by SMF