Become a Site Supporter and Never see Ads again!
« previous next »
Pages: [1]   Go Down

Author Topic: Noise caused by burner? Static? ISO help  (Read 1939 times)

0 Members and 1 Guest are viewing this topic.

Offline Chad

  • Trade Count: (0)
  • Taperssection Regular
  • **
  • Posts: 201
  • Gender: Male
    • Trade Lists
Noise caused by burner? Static? ISO help
« on: December 22, 2003, 03:24:42 PM »
Well I just got finished doing some DAT > FLAC transfers. I first burn the WAV files for an audio disc before I converted to FLAC. I notice this periodic static type noise on some of my master WAV discs. How do I figure out where that noise is coming from? I'm thinking it has to be my burner or Nero. Any ideas?

Thanks,
Chad
Logged

Offline nic

  • Big In Japan
  • Trade Count: (1)
  • Needs to get out more...
  • *****
  • Posts: 4700
  • Gender: Male
    • half dead batteries
Re:Noise caused by burner? Static? ISO help
« Reply #1 on: December 22, 2003, 03:31:36 PM »
is DMA enabled on your hard-drives and burner?
to check, goto device mgr>IDE controllers> primary & secondary channels.
under advanced settings, transfer mode should be set to "DMA mode if available".

this would be the first things to check
Logged


the water's clean and innocent

Offline Chad

  • Trade Count: (0)
  • Taperssection Regular
  • **
  • Posts: 201
  • Gender: Male
    • Trade Lists
Re:Noise caused by burner? Static? ISO help
« Reply #2 on: December 22, 2003, 04:42:46 PM »
I changed it to DMA available in the secondary one. hopefully that will do the trick.

Thanks,
Chad
« Last Edit: December 22, 2003, 04:45:43 PM by Chad »
Logged
Pages: [1]   Go Up
« previous next »
 

RSS | Mobile
Page created in 0.099 seconds with 29 queries.
© 2002-2024 Taperssection.com
Powered by SMF