Taperssection.com
Gear / Technical Help => Battery Boxes, Preamps, Mixers, ADCs, and Processors => Topic started by: jbell on October 26, 2011, 04:50:53 PM
-
I need to know the DC resistance between its signal inputs (pins
2 or 3 on the Binder/KCY) and ground. While we are asking for favors, maybe some one could verify the VMS
low-volt supply (pin 4) is 6V as specified on the VMS diagram.
Any help would be greatly appreciated!! TIA
-
For what? You building a VMS? :P ;D
-
For what? You building a VMS? :P ;D
Sort of...
-
For what? You building a VMS? :P ;D
Sort of...
I'll take one then :) ;D
-
I need to know the DC resistance between its signal inputs (pins
2 or 3 on the Binder/KCY) and ground. While we are asking for favors, maybe some one could verify the VMS
low-volt supply (pin 4) is 6V as specified on the VMS diagram.
Any help would be greatly appreciated!! TIA
VMS02IB manual in PDF was posted by gmm6797 in this thread: http://taperssection.com/index.php?topic=57349.msg753909#msg753909 (http://taperssection.com/index.php?topic=57349.msg753909#msg753909)
-
It's not needed anymore, problem solved
I need to know the DC resistance between its signal inputs (pins
2 or 3 on the Binder/KCY) and ground. While we are asking for favors, maybe some one could verify the VMS
low-volt supply (pin 4) is 6V as specified on the VMS diagram.
Any help would be greatly appreciated!! TIA
VMS02IB manual in PDF was posted by gmm6797 in this thread: http://taperssection.com/index.php?topic=57349.msg753909#msg753909 (http://taperssection.com/index.php?topic=57349.msg753909#msg753909)