Taperssection.com
Gear / Technical Help => Cables => Topic started by: paulbaptiste on February 01, 2009, 12:27:25 PM
-
Got a set of 8533x adapters to run my hacked naks off of phantom power. I assume i can just cut my cable (minixlr) and wire them directly to the adapter. I opened it up and it has three screw down connections labeled R, Y, S.
If i cut the cable, which is black, white, shield, where do i put these to get the proper connections? It seems like this should be a simple thing i could handle without sending them off anywehre. thanks for any input.
Nick
I can take some pictures if need be
-
found a diagram showing how to take apart and attach the wires, RYS, red yellow shield, i have black white and shield. any help?
-
Though you may want to double check with busman on this, I would say that it should go something like this:
shield: shield
red: white
yellow:black
Good Luck!
Nick
-
thanks for the response, i kinda tricked myself on this, trying to follow the pin positions, each were different from the 8533x to the mini xlr, to the deck itself, in the end i wired black to red, white to yellow, shield to shield, had one of the hots, negs, mixed and it didn't work right, so i assume i'm good now. thanks again
Nick