Topic: Sbd > MiniMe question

[phreshie]

Can anyone help on the jumper settings on the MM for running off a sbd patch ..... a friend wants to run the Rads Friday, and Kenny's signal being a little weak ...... could this be attenuated somehow ?? Settings ??

thanks

[stirinthesauce]

go to apogee's website.  Download the manual.  There is a detailed picture and desciption on how to change the jumpers to low gain.  Very easy.  Might take all of 10minutes the first time to read it, crack open the mme and change the jumpers.

To run line in and bypass the gain stage, keep the level knobs clicked off.  Use a jewelers screwdrive to adjust trim on the tiny inlayed screws next to gain pots.  Otherwise, apply gain to use the pre's

ohh and plustee on taping the rads 

[phreshie]

thanks for the info and the plusT whatever those are ? - If I only had one for everytime I taped the rads going back to cass days.
should be a hoot - old factory 4th floor near Battleship Cove. BYOB if anyone is attending.

[stober]

To run line in and bypass the gain stage, keep the level knobs clicked off.  Use a jewelers screwdrive to adjust trim on the tiny inlayed screws next to gain pots. 

This is how I would run mine.You get plenty of gain using just the A/D stage using the trim pots. Using the purple gain knobs your are engaging the mic preamps.

[phreshie]

Nice ! - thanks guys - I dont have the unit but you make it easy to understand, gracias. Ive seen one just never used one. Got it, keep level knobs off. I'll remember the screwdriver.

[andyjah]

Phreshie, Who are you heading down there with? I'm on the fence on going.

[phreshie]

might be solo or hi8 is on the fence as well. Im def going - I'll drive. if that helps you ..

[andyjah]

I'll give you a buzz when I get out of work tomorrow.

[phreshie]

Cool chill place as you know - plenty of time to get down there as I cant imagine they go on before 10 - doors say 8 but no way at least 9 - RI taper said to be bringing said MMe to run. I'll patch. would you tend to run yours(mme) off a board feed or would you just run your schoeps ?