Gear / Technical Help > Battery Boxes, Preamps, Mixers, ADCs, and Processors
V2>Minime ?
airbladder:
I have a minime now and a V2 on the way. Anything I need to know about running this combo? My guess is to run the v2 high and the minime low. I have only run the minime a few times so any help would be great,
Ed :-\
jpschust:
go buy yourself a tiny ass screwdriver for your calpots on the mme now.
Jason B:
do a basic calibration on the MMe to the V2 once you get it before you head out to tape. Like Jonny smart-assedly said ;) get a small screwdriver to adjust levels running line-in. This combo produces excellent results.
Charlies:
If you had a V2, after calibration (presumably at home), why would you need a little screwdriver for the mini cal pots? Wouldn't you just eq l/r levels using the V2?
-Curious m148->minime users want to know
**ps, I may have caused a couple drops in the beginning of my patcher's moe. tape from Sat b/c I dropped the friggin screwdriver into the gear bag...shuffling around I think I jolted the patched m1...finally found the screwdriver thanks to a fellow taper with a nice big ass light...a while before that, I was taping Ratdog at the Beacon and dropped the damn thing in the bag....couldn't find it...red overs going berszerk on the mini...finally I say oh well....taught me that the mini (at least line in) can take more blinking red lights that you would imagine...taped came back clean w/no overs. A moral of the story: use the V2 if at all possible over the screwdriver...ballpark it at home and then go with the V2 live...and run the mini relatively low (to answer your question)..... ;D
BC:
If you calibrate the V2 to the minime beforehand there should be no need to mess with the calpots, all level adjustment can be done on the V2.
Happy taping, nice gear!!!
Ben
Navigation
[0] Message Index
[#] Next page
Go to full version