Hi!
I recently bought a used unmodded UA-5 (110,-€).
Going to digimod it, i was thinking about a better solution then just cutting and jumpering.
Couldn't I just add two relays switched by the USB connectors 5V so that the unit works
as a digimod unit without usb connected and as a normal unit whenever it gets 5V from the
USB port?
I would add one relay being open unpowered to the place where the "cut" is done and one
that is closed unpowered at the place where the signal is jumped.
Has somebody done that before? I do not think that the SPDIF signal will degrade by
passing a small relais, but im not an electronics expert, so perhaps you foresee problems I
didn't think about - please let me know.
I'm going to ask my local electronics shop for relais that switch at 5V, hope i'll find some..
Tom