Taperssection.com
Gear / Technical Help => Battery Boxes, Preamps, Mixers, ADCs, and Processors => Topic started by: phishmarisol on May 04, 2004, 07:39:20 PM
-
Stiiiiiiiil waiting for some cables...in the meantime...when I put the batt in I get no indication that it is on. I don't think I will get one but just wondering if I am doing this right. I just put a 9 volt where it goes. I don't need any kind of connectors for it right?
-
The red light only comes on if you're low on power. Take off the optical cap. If there's a red light under there it's on. ;D
-
Just checked. Red light. Thanks! +T
-
do yourself a favor and make a 9.6 v RC battery pack for your AD-20, it will go over 14 hours on single charge (thats with a cheep one) and will pay for itself in no time, disposible 9v battery cost adds up and is bad for the enviorment.
-
Just bought a mod ad20 and plan on doing the same. Will probably make up a RC plug to 9v snap (so I can use the RC battery to replace either one)
-
I run my AD-20 and PS-2 with a 9.6v Makita drill battery. I used that because I already have a couple of them and a charger (all came with the drill). I just made a little harness out of the caps the batteries ship with. I split that out to two of those RC battery repair kit connectors which connect to two mini mono plugs for the Deneckes. Works very well. I haven't run for more than about four hours, but it was all still going strong at that point.
-
Can you guys provide a link or pics to make this battery pack?
-
what is the +/- arrangment on the DC in on the AD-20?
is it - ---Co--- +
or +----Co---- - ?
Just curious. I have a setup that can take two SLA batts that are 9.6 volts and are 3000mAh. Should last a long, long time powering the PS-2 and AD-20.
-
what is the +/- arrangment on the DC in on the AD-20?
is it - ---Co--- +
or +----Co---- - ?
Just curious. I have a setup that can take two SLA batts that are 9.6 volts and are 3000mAh. Should last a long, long time powering the PS-2 and AD-20.
Not sure what that pic is supposed to be, but it is miniplug tip positive...
-
then it is the first of the two drawing, which is standard. Thanks. I can used the same battery cable from the UA-5, just by using a different tip from the universal adaptor kit.
-
what is the +/- arrangment on the DC in on the AD-20?
is it - ---Co--- +
or +----Co---- - ?
Just curious. I have a setup that can take two SLA batts that are 9.6 volts and are 3000mAh. Should last a long, long time powering the PS-2 and AD-20.
Not sure what that pic is supposed to be, but it is miniplug tip positive...
a regular mini-plug doesn't fit in there. more like a 1/4 inch plug?
-
hmmm, does on mine, it is a mono plug tho... see the plug on the wall wort below
(http://www.soundprofessionals.com/images/gold/full/DEN-AC-1.jpg)
-
thanks, +t