Taperssection.com

Gear / Technical Help => Battery Boxes, Preamps, Mixers, ADCs, and Processors => Topic started by: heyitsmejess on December 01, 2007, 06:08:06 PM

Title: yet another mx 100 question....
Post by: heyitsmejess on December 01, 2007, 06:08:06 PM

i attempted to wire my recently purchased mx 100 to run on 2 9v batteries, using this diagram.

(http://www.nakmics.com/MX-100_Power_Schematic.jpg)

it didnt work.

my question is this.  when looking at the diagram, is this showing the power-in from the outside of the box, or the inside of the box?

thanks again TS for helping with my many questions!

Title: Re: yet another mx 100 question....
Post by: flipp on December 01, 2007, 06:33:41 PM

according to the rectangle in the bottom left of the diagram, that's inside the box

let me take the cover off mine and I'll see if I can confirm


<edit: That is the way the connector would look if you have the cover off and are looking from the level pots across the circuit board to the back side of the power connector. It should have a red wire connected to it. Counter clockwise from the 6 oclock position, red(4), blue(3), yellow(2), black(1). >

Title: Re: yet another mx 100 question....
Post by: heyitsmejess on December 01, 2007, 07:13:24 PM

alright...no wonder it didnt work!  i have some more soldering to do!

thanks!

Title: Re: yet another mx 100 question....
Post by: heyitsmejess on December 02, 2007, 12:17:57 PM

well...that wasnt the culprit.

still not working.

anyone have any ideas?

Title: Re: yet another mx 100 question....
Post by: capnhook on December 02, 2007, 08:11:31 PM

See my post in the NAK team section.......

Kevin