Become a Site Supporter and Never see Ads again!
« previous next »
Pages: [1]   Go Down

Author Topic: Tascam 112mk2 Issue  (Read 1583 times)

0 Members and 1 Guest are viewing this topic.

Offline NecroCaine

  • Trade Count: (0)
  • Taperssection Newbie
  • *
  • Posts: 7
Tascam 112mk2 Issue
« on: July 19, 2008, 09:41:40 PM »
I'm transferring cassettes on a Tascam 112 mk2. The output levels are adjustable, so I can't seem to figure out how where to set my outputs so that the final transfers match the levels on the tape exactly. It's a bit strange considering my retired, shed-ridden Sanyo POS only puts out the levels read from the tape.

Thanks for any help?

NC
Logged

Offline gmm6797

  • Trade Count: (10)
  • Needs to get out more...
  • *****
  • Posts: 3591
  • Gender: Male
  • Schoeps MK4 > nBoxPlat > Sony A10/SDMixPre6/SD 722
    • Homepage
Re: Tascam 112mk2 Issue
« Reply #1 on: July 20, 2008, 12:39:21 AM »
I am no expert, but does it matter?  You can always normalize in post, no?
Logged

Offline NecroCaine

  • Trade Count: (0)
  • Taperssection Newbie
  • *
  • Posts: 7
Re: Tascam 112mk2 Issue
« Reply #2 on: July 20, 2008, 03:53:17 AM »
The tape I'm transferring is clipped and I'd like to show that in the wav file, if possible.

Logged

Offline gmm6797

  • Trade Count: (10)
  • Needs to get out more...
  • *****
  • Posts: 3591
  • Gender: Male
  • Schoeps MK4 > nBoxPlat > Sony A10/SDMixPre6/SD 722
    • Homepage
Re: Tascam 112mk2 Issue
« Reply #3 on: July 20, 2008, 12:49:23 PM »
normalizing in post will just push everything to the max volume of the wav file.... thus adjusting the volume to the 0db level of the highest point of the recording
Logged
Pages: [1]   Go Up
« previous next »
 

RSS | Mobile
Page created in 0.06 seconds with 33 queries.
© 2002-2024 Taperssection.com
Powered by SMF