Taperssection.com
Gear / Technical Help => Ask The Tapers => Topic started by: jeromejello on April 11, 2005, 01:40:57 AM
-
anyone know where i can get one of these cheap? female 1/4" > male 5/8"
-
did you try this one?
http://www.bhphotovideo.com/bnh/controller/home?O=productlist&A=details&Q=&sku=147276&is=REG
-
local camera shop?
-
did you try this one?
http://www.bhphotovideo.com/bnh/controller/home?O=productlist&A=details&Q=&sku=147276&is=REG
yeah, i tried but it was out of stock...
-
did you try this one?
http://www.bhphotovideo.com/bnh/controller/home?O=productlist&A=details&Q=&sku=147276&is=REG
yeah, i tried but it was out of stock...
bummer! I remember seeing something like that at another place, I'll see if I can dig it up again...
-
what i use
http://www.cascademedia.net/products.asp?catid=133&prodid=677
http://www.cascademedia.net/products.asp?catid=133&prodid=678
-
what i use
http://www.cascademedia.net/products.asp?catid=133&prodid=677
http://www.cascademedia.net/products.asp?catid=133&prodid=678
i almost went partially this route... i already have an extra 3/8 > 5/8... in the end, i just got hosed: 7.95 for the adapter, 8.25 to ship >:(
i dont even want to link the site... :'(
-
do you care if it is permanent?
if not go to radioshack and get on of these....
(http://www.radioshack.com/images/ProductCatalog/ProductImage/33/33-372.jpg)
http://www.radioshack.com/product.asp?catalog%5Fname=CTLG&category%5Fname=CTLG%5F007%5F002%5F013%5F000&product%5Fid=33%2D372
if the link dont work its Catalog # is 33-372
just epoxy the metal male 5/8 sleeve to the top of your mic stand. make sure you put tape around the threads when you are epoxying.
-
i need the top of the stand to have 5/8 male threads so i can screw on the at8410a.
thanks for the tip tho!
-
what i use
http://www.cascademedia.net/products.asp?catid=133&prodid=677
http://www.cascademedia.net/products.asp?catid=133&prodid=678
i almost went partially this route... i already have an extra 3/8 > 5/8... in the end, i just got hosed: 7.95 for the adapter, 8.25 to ship >:(
i dont even want to link the site... :'(
and if that wasnt bad enough, now they are claiming to be backordered! muthafucka!
still looking...
(btw, cascade media is in the middle of switching offices... just not a good time i guess)
-
i need the top of the stand to have 5/8 male threads so i can screw on the at8410a.
thanks for the tip tho!
check this out
http://taperssection.com/index.php?topic=25474.0
-
thanks... but i found a 1/4 > 3/8 bogen adapter at a camera shop locally and then just used the extra 3/8 > 5/8 adapter that i had.
problem solved.