This is what Ryan at Telefunken set me. Five conductors but not the same pin assignment as you listed (unless you were listing the number of conductors and not there corresponding pin assignment).
Hello,
Here's the pinout information as we discussed on the phone for the ELA M 260 cable.
ELA M 260 Pinout:
1. B+ Voltage (120V)
2. Heater Voltage (6.0V) - use heavier conductor if available
3. No Contact in mic - a conductor is still run, but can be left out if one less conductor is available
4. No Contact in mic - a conductor is still run, but can be left out if one less conductor is available
5. (+) Audio
6. (-) Audio
7. Circuit Ground - use heavier conductor if available
Shield. Cable Shielding
In the PSU, the circuit ground is tied to the cable shielding.
This pinout is sent pin-to-pin from PSU to the mic, therefore is the same pin assignments coming out of the PSU as is coming into the mic.
Please let me know if you have any questions. Glad to hear you are enjoying the 260's!
Thanks,
Ryan Loftus
Design Engineer
TELEFUNKEN Elektroakustik
300 Pleasant Valley Road Suite E
South Windsor, CT 06074
TEL: [+1] 860.882.5919
FAX: [+1] 860.882.5980
http://www.t-funk.com