It is possible (although not likely) that it was wired incorrectly by SP or the switch configuration in the instructions is incorrect. One way to tell what's going on would be to feed some pink noise through it and then look at the frequency spectrum of the resulting lossless file. Then try a different combination of switches (start with the opposite of the 16Hz with only the 1 open).
hmm, i dont know. i have it switched to 'open' properly and all that,i doubt somethings wrong too but maybe i should try the opposite of the switches like your saying. nice!
I'll run it through and play with the settings and get back with the results.
how do you run pink noise ? i will have to look that up some more.
thanks for the response, this place is great! always was!