Taperssection.com

Gear / Technical Help => Recording Gear => Topic started by: fuzzytreebeard on February 19, 2017, 02:00:15 PM

Title: Tasmcam Dr-44 Help(new)
Post by: fuzzytreebeard on February 19, 2017, 02:00:15 PM
I am attempting to get all 4 channels to record. When I'm finished recording it creates a file for channel 3 & 4 but no audio plays from the files nor do they register on the device as receiving audio (bars jumping up and down). I had a pair of mics plugged in as well last night. On 4 ch mode please if anyone has any ideas please let me know.
Title: Re: Tasmcam Dr-44 Help(new)
Post by: willndmb on February 19, 2017, 06:18:12 PM
Did you have levels for all four?
Were they showing as mono or stereo pairs?

I'm also assuming you saw the firmware upgrade, did you install it?
If yes, did you have this issue at all before? If not, suggest doing it.

Here is the manual of you need it too http://tascam.com/content/downloads/products/861/dr-44wl_om_ve_2.pdf
Title: Re: Tasmcam Dr-44 Help(new)
Post by: mysticeyes on February 20, 2017, 08:17:01 PM
Did channels 3 & 4 have phantom power turned on?
Title: Re: Tasmcam Dr-44 Help(new)
Post by: fuzzytreebeard on February 21, 2017, 03:30:58 PM
No they did not. Is that the button I slide that says phantom power + mic
Title: Re: Tasmcam Dr-44 Help(new)
Post by: willndmb on February 21, 2017, 09:24:28 PM
Quote from: fuzzytreebeard on February 21, 2017, 03:30:58 PM
No they did not. Is that the button I slide that says phantom power + mic
yes, depending on the mics they may need phantom/48v to run orrrr they may not