Gear / Technical Help > Cables

V2 Power Cable question (semi urgent)

<< < (2/3) > >>

kindms:

--- Quote from: tgakidis on August 01, 2017, 07:46:23 PM ---Not sure about the eco charge batts but my guess is your v2 is a 12v model.

--- End quote ---

ted if you have a second can you take a look at this and maybe it makes sense to you

http://www.taperssection.com/reference/pdf/Manual_EcoChargeEC90.pdf

It talks about 12v being industry standard but something different about the regulated circuit and a jumper to pin 4 or something

tgakidis:
Ok, you v2 must be 6v then which is pin2 -, pin 3+.

kindms:

--- Quote from: tgakidis on August 03, 2017, 05:04:35 AM ---Ok, you v2 must be 6v then which is pin2 -, pin 3+.

--- End quote ---

the power cord is def setup for 6v confirmed by inspecting the ends,

so does the link suggest standard 6v wiring wont work but need something special on the eco side ?

tgakidis:
You would need 6v config on the v2 side and 12v config on the battery side.  6v V2's have a range of 6-12v so this should work just fine.

kindms:

--- Quote from: tgakidis on August 03, 2017, 08:02:23 AM ---You would need 6v config on the v2 side and 12v config on the battery side.  6v V2's have a range of 6-12v so this should work just fine.

--- End quote ---

Ted will you be in NYC Friday or Sat for Phish ? And if so can you build me a cable ? Ill ask you to build it regardless but was wondering if you were coming down for shows.

Navigation

[0] Message Index

[#] Next page

[*] Previous page