Gear / Technical Help > Battery Boxes, Preamps, Mixers, ADCs, and Processors
best way to send signal from V3>Dr680
fsulloway:
--- Quote from: mattmiller on March 29, 2019, 02:52:59 PM ---
--- Quote from: rocksuitcase on March 29, 2019, 02:22:57 PM ---
--- Quote from: mattmiller on March 29, 2019, 01:43:06 PM ---OK, that's good to know. I didn't do any further testing with it on 7/8, but 5/6 worked out great at my two shows last week. This will be my go-to setup going forward. The only "problem" was dealing with my 3-foot digi cable. My searches so far haven't turned up any options in the 12-inch range with right-angle connections. I know I can buy the right-angle adapters, but even fining a single RCA cable that short has eluded me so far.
--- End quote ---
Gakcables is your answer. PM Ted and ask him to build you one. His TS handle is tgakidis
https://taperssection.com/index.php?topic=133186.0
https://taperssection.com/index.php?action=profile;u=19317
--- End quote ---
Oh, I'm well acquainted with Ted. He hooked me up with a new battery cable for the V3 a couple weeks ago (the Tekkeon that was dedicated to the V3 wouldn't hold a charge, so I had to buy a new one, which required a different cable). I was just looking for an off-the-shelf version before commissioning another custom job.
--- End quote ---
I've got a digi rt angle to rt angle cable just over afoot long that I used from my V3 to dr680. Getting ready to put it up in the YS if you're interested.
Navigation
[0] Message Index
[*] Previous page
Go to full version