Become a Site Supporter and Never see Ads again!
« previous next »
Pages: [1]   Go Down

Author Topic: M-Audio 410  (Read 1837 times)

0 Members and 1 Guest are viewing this topic.

Offline discopanic1

  • Trade Count: (0)
  • Taperssection Regular
  • **
  • Posts: 192
  • Gender: Male
M-Audio 410
« on: March 28, 2006, 12:08:17 PM »
I just purchased the M-Audio 410 to use in DAT>PC conversion with the FireWire.  I also might try to use it as a pre in recording me and my bunch of friends playing music at the start to see what it is about.  I know it isn't gonna be anything close to the V3 but I wanna hear some fead back on the pre's in it.

Jesse Mc

Mk4/CMC6 > V3
Logged

zowie

  • Guest
  • Trade Count: (0)
Re: M-Audio 410
« Reply #1 on: March 28, 2006, 08:36:32 PM »
They're reasonably quite and I find them inoffensive.  Bottom end a little soft.  Go have fun!
Logged

Offline Chanher

  • Trade Count: (2)
  • Taperssection All-Star
  • ****
  • Posts: 1382
  • Colorado Crew
Re: M-Audio 410
« Reply #2 on: March 29, 2006, 08:41:37 PM »
I have not run a stock 410, but doug oade says the sounds isn't too far from a stock ua-5

http://www.oade.com/Tapers_Section/Forum/dcboard.php?az=show_mesg&forum=100&topic_id=1312&mesg_id=1320&page=
Logged
Line Audio CM4 / AT853Rx (c,h,o) / Studio Projects C4 MKII (c,h,o)
Sound Devices MP-2 / bm2p+ Edirol UA-5
Zoom F3 / F6 / Marantz Oade Warm Mod PMD661 / Tascam DR-70D

Offline discopanic1

  • Trade Count: (0)
  • Taperssection Regular
  • **
  • Posts: 192
  • Gender: Male
Re: M-Audio 410
« Reply #3 on: April 02, 2006, 04:06:59 AM »
This might actually be a good investment, only time and tapes will tell.  I'm going to set up my Mk4's running out of the 410 only into my Inspiron 6000 to test and see the pre's in it.  Then later in the testing I'm going to mic each instrument to run in and make a recording in that sense. 
Logged
Pages: [1]   Go Up
« previous next »
 

RSS | Mobile
Page created in 0.068 seconds with 32 queries.
© 2002-2024 Taperssection.com
Powered by SMF