Gear / Technical Help > Photo / Video Recording
Panasonic Lumix DC-ZS200 (edit: mostly about ZS100 though)
Papaphunk:
Question for the Masses. What adjustments would you make so the video's on the screen would display better, while also keeping the band members intact.
https://www.youtube.com/watch?v=Hodw1yNLsK8&t
I've followed most of the settings discussed within this thread, just looking to tighten up the video display a little bit.
thanks
O0
ol' dirty taper:
--- Quote from: Papaphunk on April 05, 2024, 09:23:52 AM ---Question for the Masses. What adjustments would you make so the video's on the screen would display better, while also keeping the band members intact.
https://www.youtube.com/watch?v=Hodw1yNLsK8&t
I've followed most of the settings discussed within this thread, just looking to tighten up the video display a little bit.
thanks
O0
--- End quote ---
I've been finding that in post if I reduce the saturation a touch and bring down highlights, up the shadows, that clarity is brought out a bit more. Otherwise, the images are similar to yours when raw, a bit soft on the focus.
Here is my most recent video, can see a similar look.
Balthvs Live at SLO Brew 2024.03.26
https://youtu.be/0kGkb0dks4c?si=aWycCp5c-wWx3Hos
checht:
--- Quote from: ol' dirty taper on April 05, 2024, 12:24:57 PM ---Here is my most recent video, can see a similar look.
Balthvs Live at SLO Brew 2024.03.26
https://youtu.be/0kGkb0dks4c?si=aWycCp5c-wWx3Hos
--- End quote ---
Wow, those guys are great! What mics did you record with, and what location?
ol' dirty taper:
--- Quote from: checht on April 05, 2024, 06:18:30 PM ---
--- Quote from: ol' dirty taper on April 05, 2024, 12:24:57 PM ---Here is my most recent video, can see a similar look.
Balthvs Live at SLO Brew 2024.03.26
https://youtu.be/0kGkb0dks4c?si=aWycCp5c-wWx3Hos
--- End quote ---
Wow, those guys are great! What mics did you record with, and what location?
--- End quote ---
Check them out! They are touring again later in the year and are wide open to tape.
I run a pair of MK21s and MG M300s with a board source. Setup right in front of the board, which is the very back of this room. I like how it sounds, but I am considering doing a combination of this setup with stage mics in the future.
beatkilla:
--- Quote from: Papaphunk on April 05, 2024, 09:23:52 AM ---Question for the Masses. What adjustments would you make so the video's on the screen would display better, while also keeping the band members intact.
https://www.youtube.com/watch?v=Hodw1yNLsK8&t
I've followed most of the settings discussed within this thread, just looking to tighten up the video display a little bit.
thanks
O0
--- End quote ---
You will need to do that in post production.
Since your camera is not moving and on a stand it is possible.
Using bezier masking.
Make 2 tracks of the same video, the one on the top track you can make a mask that cuts out the video screen above the musicians.
Basically cutting a hole in the top video now on the track below it will still look the same until you lower the brightness on the 2 nd track below where you will now have the top track at normal brightness with the screen cut out showing through to the bottom track with the new brightness adjustment for the screen.
Render it out.
Good luck
Navigation
[0] Message Index
[#] Next page
[*] Previous page
Go to full version