Become a Site Supporter and Never see Ads again!

Author Topic: DIY LiPo battery pack for MixPre-6  (Read 3763 times)

0 Members and 1 Guest are viewing this topic.

Offline lerond

  • Trade Count: (5)
  • Taperssection Regular
  • **
  • Posts: 62
  • Gender: Male
DIY LiPo battery pack for MixPre-6
« on: October 22, 2020, 02:19:09 AM »
Stumbled onto a pretty cool page about a roll your own MixPre battery pack the other day:

I dig the idea that using the rear power connectors leaves the On/Off switch more accessible -- my fingers are so fat that it's really hard for me to operate the switch when a UCB-C connector is plugged in.
ain't no party like a katydid party
jumpin' and a hoppin' and singin' them songs!

Offline heathen

  • Trade Count: (23)
  • Needs to get out more...
  • *****
  • Posts: 3529
Re: DIY LiPo battery pack for MixPre-6
« Reply #1 on: October 22, 2020, 05:09:01 PM »
Neat.  Yet another reason to get into 3D printing.  The author mentions a potential issue with swelling but I wonder if heat could be a concern as well?
Mics: AT4050ST | AT4031 | AT853 (C/SC) | Line Audio CM3 | Sennheiser e614 | Sennheiser MKE2 | DPA 4061 Pre: CA9200 Decks: Zoom F8 | Roland R-05


RSS | Mobile
Page created in 0.043 seconds with 25 queries.
© 2002-2024
Powered by SMF