Topic: Sample rate switch on D8

[greenone]

Does this switch matter when you're running a digi in to the D8? I accidentally bumped it at some point while running last night and didn't notice until the show was almost over. Got home, popped the tape in my DA-20 to convert and went to bed, woke up and checked the recording and the transfer is all fucked up. Swore a few times, threw it in the SV-3700 and it appears to be playing back just fine, so I'm keeping my fingers crossed. But I thought a digi signal is a digi signal (it's from a 48kHz ADC-20) and couldn't be re-sampled by the deck, right?

--Dave

[Sean Gallemore]

right

[F.O.Bean]

youre good if its an adc, those crystals are internal and cannot be changed, so the recording will be 48k if sending a digital signal

[greenone]

Ok, good...2 for 2. Must just be my DA-20 being a bitch. I'll go home and smack it around some. Thanks!

[F.O.Bean]

try a dry cleaning tape, that sometimes helps

and dave, im gonna try that eco on a bulk charger, i dont believe that an eco died that easily

[greenone]

Cool, uh, beans...bean. My luck with batteries continues - one of my BP-50s won't fully charge now. Light on the charger just stays orange forever. This is not good.

[F.O.Bean]

sucky