Gear / Technical Help > Microphones & Setup
ISO: Spread omni mount/bar options
boa:
I'm moving to an nbob active setup and want a bar that I can use to spread between two Shure a53m doughnuts. In the past when using 4061's, I've connected a pair of Shure transmitter antennas and extended them outward from each side of the stand, but what material could I use for the heavier, fullsize MG capsules & nbob colletes?
is there any off the shelf solution I should consider? I have a Manfrotto 154 Triple Bar but am looking for something sleeker and light weight, preferably something that collapses or folds. Thanks for your help!
fireonshakedwnstreet:
Check out the SmallRig15 mm camera rails and their mounting hardware. Can go 3 or 4 feet (and probably more) with no problem and they are pretty solid. You can unscrew the different section. I run 2 pairs of SDCs (AT 3031s, Studio Projects C4s) plus the mini omnis on the ends without issue (check my rig pics). Rocksuitcase turned me on to those.
seethreepo:
https://www.smallrig.com/smallrig-rod-pack-6-pcs-1659.html
audBall:
--- Quote from: seethreepo on December 29, 2021, 11:47:00 PM ---https://www.smallrig.com/smallrig-rod-pack-6-pcs-1659.html
--- End quote ---
+T's for the SmallRig recommendation.
This will really enhance my extendable DIY mounting solution. I love options that have the ability to extend to greater widths, but also allow for breakdown to a very small footprint.
Gutbucket:
That's a nice modular solution from SmallRig. It's looks a lot like the system audBall put together for himself in DIY fashion, which is IMHO one of the best solutions I've seen.
Navigation
[0] Message Index
[#] Next page
Go to full version